Aegis LH630-775 — Section 11 - Reassembly

Section 11 Reassembly Figure 11-95. Fan Assembly (Front View). Figure 11-97. Torquing Upper Pulley Assembly. 8. Carefully work the belt into place on the pulleys. See Figure 11-98. Check the belt tension. There should be no more than 9.53 - 12.7 mm (3/8" - 1/2") belt deflection per side with 10 lbs. of applied tension. See Figure 11-99. Figure 11-96. Fan Assembly (Rear View). Make sure one flat washer is placed between the two bearings in the hub. The other washer is located under the front hex flange nut. Torque the four fan/pulley/hub mounting screws to 6.8 N·m (60 in. lb.) . Figure 11-98. Working Belt onto Pulley. 6.

If the fan shaft was removed from the upper mounting bracket, apply Loctite ® No. 242 to the rear threads. Install and torque the rear hex nut to 15.8 N·m (140 in. lb.) . Install the fan and pulley assembly onto the fan shaft and upper mounting bracket. 7. Apply Loctite ® No. 242 to the front threads of the fan shaft. Install the flat washer and the hex flange nut to secure. Torque hex flange nut to 15.8 N·m (140 in. lb.) . See Figure 11-97. Figure 11-99. Belt Deflection/Tension Checking. 11.27 11