Aegis LH630-775 — Section 11 - Reassembly

Section 11 Reassembly If the belt tension is low, remove the belt and relocate a shim from between the pulley halves to the outside (front). Reinstall the belt and recheck the tension. Repeat the procedure until the correct tension is reached. if the shims have all been moved to the outside, and the belt is still too loose, replace the belt. Install Air Cleaner Assembly 1. Install a new elbow adapter gasket onto the carburetor adapter. See Figure 11-102. NOTE: Do not assemble the lower pulley with the belt between the pulley halves, as pinching of the belt or damage to the pulley can occur. When proper tension is obtained, individually remove each capscrew, apply Loctite ® No.

242 to the threads of lower pulley and reinstall. Torque the four bolts in a criss-cross sequence to 24.3 N·m (215 in. lb.) . See Figure 11-100. Figure 11-102. Installing Elbow Adapter Gasket. 2. Set the air cleaner/mounting bracket assembly, with the hose and elbow attached, in position on the engine. Align all of the mounting holes. Start and finger tighten each of the mounting screws. Make sure the fuel line is outside of the main bracket when installed. See Figures 11-103 and 11-104. Figure 11-100. Torquing Lower Pulley Screws. 9. Mount the RH and LH lower radiator supports with cross support bracket attached, to the crankcase, using the four hex flange screws.

Snug the screws only at this time. See Figure 11-101. Figure 11-103. Installing Air Cleaner Assembly. Figure 11-101. Mounting Lower Radiator Supports. 11.28