Section 11 Reassembly 1 3 4 2 Figure 11-104. Fuel Line Hose Routing Outside Leg of Air Cleaner Bracket. Figure 11-107. Torque Sequence. 3. Torque the two elbow mounting screws to 7.3 N·m (65 in. lb.) . See Figure 11-105. Then torque the eight valve cover mounting screws to 6.2 N·m (55 in. lb.) in the sequence shown in Figure 11-107. 4. If removed, install the rain cap and secure with the clamp. Check the position of the dust ejector, it should face downward. Adjust the end cap position as required. See Figure 11-108. Figure 11-105. Torquing Elbow Mounting Screws. Figure 11-108. Dust Ejector Valve and Rain Cap Position. 5. Connect the wires for the audible alarm, if used.
11 Install Radiator Assembly 1. Reassemble the components of the radiator assembly, including upper and lower radiator hoses. Rubber lubricant may be applied to the inner surfaces of the hoses to make installation easier. Secure with the hose clamps. The radiator subassembly should look as shown in Figure 11-109. Figure 11-106. Torquing Valve Cover Screws. 11.29