Section 5B EFI Fuel System a. If the resistance is greater than 1.0 M Ω , go to step 5. 4. Reconnect the lead to wiring harness connector. Make sure it can not contact hot surfaces, moving parts, etc. b. If the resistance is less than 1.0 M Ω , the sensor is bad, replace it. 5. Test run the engine. 5. With the oxygen sensor disconnected and engine not running, disconnect the main harness connector from the ECU and set the meter to the Rx1 scale. Check for circuit continuity from pin #19 of the ECU connector (see page 5B.24) to the shell of the oxygen sensor, and from pin #20 to the sensor terminal of the main harness. Both tests should indicate continuity. Electrical Relay a.
If there is no continuity displayed in either of the tests, check the harness circuit for breaks or damage, and the connections for poor contact, moisture, or corrosion. If no continuity was found in the first test, also check for a poor/broken ground path back through the exhaust system, engine, and mounting (sensor is grounded through its shell). Figure 5B-10. Electrical Relay. b. If continuity is indicated, go to step 6. General The electrical relay is used to supply power to the injectors, coils, and fuel pump. When the key switch is turned “on” and all safety switch requirements met, the relay provides 12 volts to the fuel pump circuit, injectors, and ignition coils.
The fuel pump circuit is continuously grounded, so the pump is immediately activated and pressurizes the system. Activation of the ignition coils and injectors is controlled by the ECU, which grounds their respective circuits at the proper times. 6. With the key switch in the ‘‘on/run’’ position, using a high impedance voltmeter, check the voltage from the wiring harness oxygen sensor connector to the engine ground location. Look for a steady voltage from 350-550 mv (0.35 - 0.55 v) . a. If the voltage reading is not as specified, move the black voltmeter lead to the negative post of the battery, to be certain of a good ground. If the voltage is still not correct, the ECU is probably bad.
Service A malfunctioning relay can result in starting or operating difficulties. The relay and related wiring can be tested as follows. b. If the voltage readings are correct, clear the fault codes and run the engine to check if any fault codes reappear. 1. Disconnect the relay connector plug from the relay. To Replace Oxygen Sensor: 1. Disconnect the oxygen sensor connector from wiring harness. 2. Connect the black lead of a VOA meter to a chassis ground location. Connect the red lead to the #86 terminal in relay connector (see Figure 5B-11). Set meter to test resistance (Rx1). Turn the key switch from to Meter should indicate continuity (ground circuit is completed) for 1 to 3 seconds.
Turn key switch back off. 2. Loosen and remove the oxygen sensor from the exhaust manifold/muffler assembly. 3. Apply anti-seize compound sparingly to threads of new oxygen sensor, if none already exists. DO NOT get any on the tip as it will contaminate the sensor. Install sensor and torque to 50-60 N·m (37-44 ft. lb.) . 5B.11 5B