Section 5B EFI Fuel System Terminal #87 - Feed To Ignition Coils, Fuel Injectors, and Fuel Pump 5. Connect an ohmmeter (Rx1 scale) between the #85 and #86 terminals in the relay. There should be continuity. Terminal #85 - Ignition Switch Voltage 6. Attach ohmmeter leads to the #30 and #87 terminals in relay. Initially, there should be no continuity. Using a 12 volt power supply, connect the positive (+) lead to the #85 terminal and touch the negative (-) lead to the #86 terminal. When 12 volts is applied, the relay should activate and continuity should exist (circuit made) between the #30 and #87 terminals. Repeat the test several times.
If, at any time the relay fails to activate the circuit, replace the relay. Terminal #87A - Not used Terminal #86 - ECU Controlled Ground Terminal #30 - Permanent Battery Voltage Figure 5B-11. Relay Connector. a. Clean the connection and check wiring if circuit was not completed. Fuel Injectors 3. Set the meter for DC voltage. Touch the red tester lead to the #30 terminal in relay connector. A reading of 12 volts should be indicated at all times. 4. Connect the red lead of meter to the #85 terminal in the relay connector. Turn the key switch to the “on” position. Battery voltage should be present. a. No voltage present indicates a problem in the wiring or at the connector. b.
If voltage is present, the wiring to the connector is good. Turn ignition switch ‘‘off’’ and proceed to test 5 to test the relay. Figure 5B-13. Fuel Injector. Terminal #86 - ECU Controlled Ground Terminal #87 - Feed To Ignition Coils, Fuel Injectors, and Fuel Pump General The fuel injectors mount into the intake manifold, and the fuel rail attaches to them at the top end. Replaceable O-Rings on both ends of the injector prevent external fuel leakage and also insulate it from heat and vibration. A special clip connects each injector to the fuel rail, retaining it in place.
Terminal #85 - Ignition Switch Voltage Terminal #87A - Not used When the key switch is on and the relay is closed, the fuel rail is pressurized, and voltage is present at the injector. At the proper instant, the ECU completes the ground circuit, energizing the injector. The valve needle in the injector is opened electromagnetically, and the pressure in the fuel rail forces fuel down through the inside. The “director plate” at the tip of the injector (see inset) contains a series of calibrated openings which directs the fuel into the manifold in a cone-shaped spray pattern. Terminal #30 - Permanent Battery Voltage Figure 5B-12. Relay Terminal Details. 5B.12