Section 5B EFI Fuel System 1 2 3 4 5 6 7 Multi-Orifice Director Plate With Calibrated Opening 3. Disconnect the electrical connector from an injector and listen for a change in idle performance (only running on one cylinder) or a change in injector noise or vibration. If an injector is not operating, it can indicate either a bad injector, or a wiring/electrical connection problem. Check as follows: 1. Filter strainer in fuel supply 2. Electrical connection 3. Solenoid winding 4. Valve housing 5. Armature 6. Valve body 7. Valve needle Figure 5B-14. Fuel Injector Details. NOTE: Do not apply voltage to the fuel injector(s). Excessive voltage will burn out the injector(s).
Do not ground the injector(s) with the ignition Injector(s) will open/ turn on if the relay is energized. The injector is opened and closed once for each crankshaft revolution, however only one-half the total amount of fuel needed for one firing is injected during each opening. The amount of fuel injected is controlled by the ECU and determined by the length of time the valve needle is held open, also referred to as the “injection duration” or “pulse width”. It may vary in length from 1.5-8 milliseconds depending on the speed and load requirements of the engine. 1. Disconnect the electrical connector from both injectors.
Plug a 12 volt noid light (part of EFI Service Kit, see Section 2) in one connector. Service Injector problems typically fall into three general categories: electrical, dirty/clogged, or leakage. An electrical problem usually causes one or both of the injectors to stop functioning. Several methods may be used to check if the injectors are operating. 1. With the engine running at idle, feel for operational vibration, indicating that they are opening and closing. 2. When temperatures prohibit touching, listen for a buzzing or clicking sound with a screwdriver or mechanic’s stethoscope (see Figure 5B-15). Figure 5B-16. Volt Noid Light. 5B.13 Listen Here 5B Figure 5B-15. Checking Injectors.