Section 5B EFI Fuel System 2. Make sure all safety switch requirements are met. Crank the engine and check for flashing of noid light. Repeat test at other connector. 1. Engine must be cool. Depressurize fuel system through the test valve in fuel rail. 2. Disconnect the spark plug leads from spark plugs. a. If flashing occurs, use an ohmmeter (Rx1 scale) and check the resistance of each injector across the two terminals. Proper resistance is 12-20 Ω . If injector resistance is correct, check whether the connector and injector terminals are making a good connection. If the resistance is not correct, replace the injector following steps 1-8 and 13-16 below. 3.
Remove the air cleaner outer cover, inner wing nut, element cover and air cleaner element/ precleaner. Service the air cleaner components as required. 4. Remove the two screws securing the air cleaner base to throttle body manifold. Remove the air cleaner base to permit access to the injectors. Check condition of air cleaner base gasket, replace if necessary. b. If no flashing occurs, reattach connectors to both injectors. Disconnect the main harness connector from the ECU and the connector from the relay. Set the ohmmeter to the Rx1 scale and check the injector circuit resistance as follows: Check the resistance between relay terminal #87 and pin #14 in the main connector.
Then check the resistance between relay terminal #87 and pin #15. Resistance should be 4-15 Ω for each circuit. 5. Remove the flywheel screen if it overlaps the blower housing. 6. If the engine has a radiator-type oil cooler mounted to the blower housing, remove the two oil cooler mounting screws. Check all electrical connections, connectors, and wiring harness leads if resistance is incorrect. 7. Remove the blower housing mounting screws. Note the location of the plated (silver) screw attaching the rectifier/regulator ground lead. Remove the blower housing.
Injector leakage is very unlikely, but in those rare instances it can be internal (past the tip of the valve needle), or external (weeping around the injector body). See Figure 5B-17. The loss of system pressure from the leakage can cause hot restart problems and longer cranking times. To check for leakage it will be necessary to remove the blower housing, which may involve removing the engine from the unit. 8. Thoroughly clean the area around and including the throttle body/manifold and the injectors. 9. Disconnect the throttle linkage and damper spring from the throttle lever. Disconnect the TPS lead from the harness. 10.
Remove the manifold mounting bolts and separate the throttle body/manifold from the engine leaving the TPS, fuel rail, air baffle, injectors and line connections intact. Discard the old gaskets. 11. Position the manifold assembly over an appropriate container and turn the key switch to activate the fuel pump and pressurize the system. Do not turn switch to “start” position. Check For Leaks 12. If either injector exhibits leakage of more than two to four drops per minute from the tip, or shows any sign of leakage around the outer shell, turn the ignition switch off and replace injector as follows. Figure 5B-17. Injector Inspection Points. 5B.14