Section 5B EFI Fuel System 13. Depressurize the fuel system following the procedure in the fuel warning on page 5B.2. Remove the two fuel rail mounting screws. Service Except for removing the spark plug lead by unscrewing it from the secondary tower (see Figure 5B-18), no coil servicing is possible. If a coil is determined to be faulty, replacement is necessary. An ohmmeter may be used to test the wiring and coil windings. 14. Clean any dirt accumulation from the sealing/ mounting area of the faulty injector(s) and disconnect the electrical connector(s). 15. Pull the retaining clip off the top of the injector(s) and remove from manifold. 16.
Reverse the appropriate procedures to install the new injector(s) and reassemble the engine. Use new O-Rings any time an injector is removed (new replacement injectors include new O-Rings). Lubricate O-Rings lightly with oil. Torque fuel rail and blower housing mounting screws to 3.9 N·m (35 in. lb.) , and the intake manifold and air cleaner mounting screws to 9.9 N·m (88 in. lb.) . Injector problems due to dirt or clogging are generally unlikely, due to the design of the injectors, the high fuel pressure, and the detergent additives in the gasoline.
Symptoms that could be caused by dirty/ clogged injectors include rough idle, hesitation/ stumble during acceleration, or triggering of fault codes related to fuel delivery. Injector clogging is usually caused by a buildup of deposits on the director plate, restricting the flow of fuel, resulting in a poor spray pattern. Some contributing factors to injector clogging include higher than normal operating temperatures, short operating intervals, and dirty, incorrect, or poor quality fuel. Cleaning of clogged injectors is not recommended; they should be replaced. Additives and higher grades of fuel can be used as a preventative measure if clogging has been a problem. Figure 5B-18.
Ignition Coil. NOTE: Do not ground the coils with the ignition as they may overheat or spark. 1. Disconnect the main harness connector from ECU. Locate pins #30 and #31 in the 32 pin connector. See page 5B.24. 2. Disconnect the connector from the relay and locate terminal #87 in connector. 3. Using an ohmmeter set on the Rx1 scale, check the resistance in circuits as follows: Check between terminal #87 and pin #30 for coil #1. Repeat the test between terminal #87 and pin #31 for coil #2. Ignition System A reading of 1.8-4.0 Ω in each test indicates that the wiring and coil primary circuits are OK. General A high voltage, solid state, battery ignition system is used with the EFI system.
The ECU controls the ignition output and timing through transistorized control of the primary current delivered to the coils. Based on input from the speed sensor, the ECU determines the correct firing point for the speed at which the engine is running. At the proper instant, it releases the flow of primary current to the coil. The primary current induces high voltage in the coil secondary, which is then delivered to the spark plug. Each coil fires every revolution, but every other spark is “wasted.” a. If the reading(s) are not within specified range, check and clean connections and retest. b.
If the reading(s) are still not within the specified range, test the coils separately from the main harness as follows: 1. Disconnect the red and black primary leads from the coil terminals. 2. Connect an ohmmeter set on the Rx1 scale to the primary terminals. Primary resistance should be 1.8-2.5 Ω . 5B.15 5B