Aegis LH630-775 — Section 5B - EFI Fuel System

Section 5B EFI Fuel System 3. Disconnect the secondary lead from the spark plug. Connect an ohmmeter set on the Rx10K scale between the spark plug boot terminal and the red primary terminal. Secondary resistance should be 13,000-17,500 Ω . Battery Charging System EFI engines are equipped with either a 15 or 25 amp charging system to accommodate the combined electrical demands of the ignition system and the specific application. Charging system troubleshooting information is provided in Section 8. 4. If the secondary resistance is not within the specified range, unscrew the spark plug lead nut from the coil secondary tower and remove the plug lead.

Repeat step b3, testing from the secondary tower terminal to the red primary terminal. If resistance is now correct, the coil is good, but the spark plug lead is faulty, replace the lead. If step b2 resistance was incorrect and/or the secondary resistance is still incorrect, the coil is faulty and needs to be replaced. Fuel Components Fuel Pump Spark Plugs EFI engines require resistor spark plugs. Do not try to substitute non-resistor plugs. Internal External Wiring Harness The wiring harness used in the EFI system connects the electrical components, providing current and ground paths for the system to operate.

All input and output signaling occurs through a special all weather connector that attaches and locks to the ECU (see Figure 5B-19). Figure 5B-20. Fuel Pump Styles. General An electric fuel pump is used to transfer fuel in the EFI system. Depending on the application, the pump may be inside the fuel tank, or in the fuel line near the tank. The pumps are rated for a minimum output of 25 liters per hour at 39 psi. The pumps have an internal 60-micron filter. In addition, the in-tank style pumps will have a pre-filter attached to the inlet. In-line pump systems may also have a filter ahead of the pump on the pick-up/low pressure side.

The final filter is covered separately on pages 5B.18 and 5B.19. When the key switch is turned and all safety switch requirements are met, the ECU, through the relay, activates the fuel pump, which pressurizes the system for start-up. If the key switch is not promptly turned to the “start” position, the engine fails to start, or the engine is stopped with the key switch “on” (as in the case of an accident), the ECU switches off the pump preventing the continued delivery of fuel. In this situation, the MIL will go on, but it will go back off after 4 cranking revolutions if system function is OK. Once the engine is running, the fuel pump remains on. Figure 5B-19.

“32 Pin” (MSE 1.1) Plastic-Cased ECU Connector. The condition of the wiring, connectors, and terminal connections is essential to system function and performance. Corrosion, moisture, and poor connections are more likely the cause of operating problems and system errors than an actual component. Refer to the ‘‘Troubleshooting – Electrical’’ section for additional information. 5B.16