Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Brakes 42 Check the mounting and connecting lines. Make sure that SAE grade 5 fasteners attaching the air dryer to the vehicle are tightened 28 lbf·ft (38 N·m) for 3/8–16 fasteners, and 45 lbf·ft (61 N·m) for 7/16–14 fasten- ers. Check all air lines, fittings, and electrical connec- tions for damage, leakage, or looseness. Replace damaged or leaking components, and tighten loose fittings and electrical connections. Anchorlok shown that extended or shortened life has re- sulted on a particular installation, then the inter- val can be increased or decreased accordingly. 42–13 Bendix Air Dryer Desiccant Replacing (AD–4 or AD–9) Disassemble, clean, and inspect the Bendix air dryer.

Replace the desiccant cartridge. See Group 42 of the Heavy-Duty Trucks Service Manual for instruc- tions. Inspect the Anchorlok aftercooler ( Fig. 10 ) for loose mountings, cracks, or other damage from external sources. Check for leakage at air fittings, the drain valve, and the automatic ejector valve. Tighten any loose mountings and leaking air fittings. If the tank leaks at cracks or seams, install a new tank using instructions in Group 42 of the Heavy-Duty Trucks Service Manual. To check operation of the automatic ejector valve, start the engine and allow air pressure to build. Watch the automatic ejector valve to make sure it ejects when the air compressor cuts out.

If the automatic ejector valve fails to operate, or if it leaks air, service it using instructions in Group 42 of the Heavy-Duty Trucks Service Manual. NOTE: Desiccant change intervals may vary from vehicle to vehicle. Although typical desic- cant cartridge life is three years, many will per- form adequately for a longer period of time. To take maximum advantage of desiccant life and assure that replacement occurs only when nec- essary, it is important to perform the other main- tenance operations in this group. 42–14 CR Brakemaster Air Dryer Cleaning (Model 62 or 68) Thoroughly steam-clean the cooling fins of the CR Brakemaster air dryer to remove road grime.

Check that the cooling fins have not been painted; if so, re- move the paint. f420006a 01/17/94 42–15 Anchorlok Aftercooler Automatic Ejector Valve Clearing Fig. 10, Anchorlok Aftercooler 42–12 Bendix Air Dryer Desiccant Replacing (AD–2) Remove the 1/8-inch pipe plug from the bottom of the automatic ejector valve. Cycle the air compressor three or four times, to blow out any moisture build-up in the valve and to ensure that lines to the valve are clear. Install and tighten the pipe plug 10 to 12 lbf·ft (14 to 16 N·m). Replace or rebuild the desiccant cartridge. For in- structions, see Group 42 of the Heavy-Duty Trucks Service Manual. NOTE:

Desiccant change intervals may vary from vehicle to vehicle; however, it is generally recommended that the cartridge be rebuilt or replaced at the interval given in the Mainte- nance Operations Chart. If experience has Heavy-Duty Trucks Maintenance Manual, October 2009 42/10