Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Brakes 42 42–16 Bendix Air Brake Valve Operation Checking (BP–R1 and E–12) damaged parts; use only genuine Bendix replace- ment parts or kits. For a DV–2 valve, lubricate the air reservoir auto- matic drain valve. If there is a filter screen in the adaptor fitting, replace it with a new one. Check for proper operation; see Group 42 of the Heavy-Duty Trucks Service Manual for instructions. Assemble and install the valves, then check for proper operation and for leakage.

42–17 Bendix Air Brake Valve Disassembly, Cleaning, and Inspecting (BP–1, Double Check Valve, E–6, PP–7, QR–1, R–6, R–14, SR–1, ST–3, TC–7, TP–5, and TR–3) 42–19 Bendix Air Brake Valve Inspecting and Testing (BP–1, BP–R1, LQ–5, PP–7, R–14, and TC–7) 1. Clean the exterior of the valves, and check them for corrosion and damage. 2. Inspect the air lines connected to the valves for signs of wear or damage. Replace the lines as needed. NOTE: See Group 42 of the Heavy-Duty Trucks Service Manual for valve removal, disassembly, inspection, assembly, and leakage-checking instructions. 3. Test the air line fittings for excessive leakage. Tighten or replace the fittings as needed. 4.

Check the valves for leakage. See Group 42 of the Heavy-Duty Trucks Service Manual for in- structions. Remove and disassemble the valves. Clean the valve parts with mineral spirits, and inspect the parts. Replace all rubber parts and any worn or damaged parts; use only genuine Bendix replace- ment parts or kits. For BP–1, LQ–5, PP–7, R–14, and TC–7 valves, check for proper operation. See Group 42 of the Heavy-Duty Trucks Service Manual for instruc- tions. Assemble and install the valves, then check for proper operation and for leakage.

42–20 Bendix Foot Brake Valve Actuator Lubricating (E–6 or E–12) and Leak- Testing (E–12) 42–18 Bendix Air Brake Valve Disassembly, Cleaning, Inspecting, and Lubricating (DV–2, PP–3, and Single Check Valve) FLA or FLB 1. Clean any dirt, gravel, and other foreign material from the base of the brake pedal, the plunger boot, and the brake base bracket. NOTE: See Group 42 of the Heavy-Duty Trucks Service Manual for valve removal, disassembly, inspection, assembly, and leakage-checking instructions. 2. Use light oil to lubricate the brake pedal roller and roller pin. Remove and disassemble the valves. Clean the valve parts with mineral spirits, and inspect the parts.

Replace all rubber parts and any worn or 3. Check the brake plunger boot for cracks, holes, or deterioration. Replace if necessary. Heavy-Duty Trucks Maintenance Manual, October 2009 42/11