Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Brakes 42 42–21 Sealco Moisture Ejection Valve Operation- and Leak-Testing (Model 6300) If there is no discharge, repair or replace the mois- ture ejection valve; for instructions, see Group 42 of the Heavy-Duty Trucks Service Manual. Check the valve again for operation. Repeat the in- structions under this heading until the valve operates as specified. If the valve fails to operate properly, install a new one. Leak-Testing Operation-Testing WARNING Keep away from the front of the moisture ejection valve exhaust outlet because moisture, scale, or other debris will be ejected with force when the compressor is cycled.

Use eye protection such as safety glasses when checking the moisture ejec- tion valve to prevent harm to your eyes from fly- ing debris. For leak-testing instructions, see Group 42 of the Heavy-Duty Trucks Service Manual. 42–22 Midland Quick Release and Flipper Valve Checking 1. Chock the tires. When the moisture ejection valve is plumbed to the governor unloader, an exhaust of air/sludge will occur only when the air compressor starts or stops pump- ing air. With the air system charged, cycle the brake foot valve until the air compressor starts pumping air. Notice if an exhaust of air/sludge occurs at the ex- haust outlet of the moisture ejection valve ( Fig.

11 ) when the air compressor starts pumping (cuts in) or stops pumping (cuts out). 2. Start the engine and run it long enough to pres- surize the air system to at least 80 psi (550 kPa), then turn off the engine. Repeat as needed, to maintain 80 psi (550 kPa) pressure during these checks. 3. Clean off road grime from the valves, and any material from all valve exhaust ports. 4. Listen for air leakage around fittings and exhaust ports. Tighten the fittings as needed; use two wrenches to avoid twisting the tubing. 1 2 If any valve fails this check, or is damaged, re- pair or replace it. Refer to the Midland service manual for instructions. 3 4 5. Remove the chocks from the tires.

42–23 Meritor WABCO System Saver 1000 Air Dryer Desiccant Replacing 5 6 7 05/28/93 f420007a Replace the desiccant cartridge. For instructions, see Group 42 of the Heavy-Duty Trucks Service Manual. 1. Reservoir Inlet 2. Upper Cap 3. Guide Post 4. Column 5. Body Casting 6. Application Line 7. Exhaust Outlet NOTE: Desiccant change intervals may vary from vehicle to vehicle. Typical desiccant car- tridge life is three years. However, if experience has shown that extended or shortened life has Fig. 11, Sealco 6300 Moisture Ejection Valve Heavy-Duty Trucks Maintenance Manual, October 2009 42/13