Brakes 42 resulted on a particular installation, then the in- terval can be increased or decreased accord- ingly. likely masking a mechanical problem. Adjustment is not repairing. Before adjusting an automatic slack adjuster, troubleshoot the foundation brake system and inspect it for worn or damaged com- ponents. Improperly maintaining the vehicle brak- ing system may lead to brake failure, resulting in property damage, personal injury, or death. 42–24 Brake Inspection IMPORTANT: This procedure should be per- formed prior to lubrication of the brake compo- nents. 2.
With the engine off, and 100 psi (689 kPa) of air tank pressure, have an assistant apply and hold an 80 to 90 psi (550 to 620 kPa) brake applica- tion. Parking Brake Operational Check 3. Check to see if the colored over-stroke band on each brake chamber pushrod is exposed. CAUTION If a band shows, the stroke is too long. Check the foundation brake components for wear or damage, and repair as needed. See Group 42 of the Heavy-Duty Trucks Service Manual for in- spection, troubleshooting, and repair procedures. Perform the following check in a clear safe area. If the parking brakes fail to hold the vehicle, per- sonal injury or property damage may result. 1.
With the engine running, and air pressure at cut- out pressure, set the parking brake. 4. Measure the applied chamber stroke. See Table 5 for the proper stroke for the type of chamber being used. If the stroke is too short, the brakes may drag or will not fully apply. Check for improper operation or adjustment of the auto- matic slack adjuster. See Group 42 of the Heavy-Duty Trucks Service Manual for inspection and troubleshooting procedures. 2. Put the vehicle in the lowest gear and gently at- tempt to move it forward. The vehicle should not move. If the vehicle moves, the parking brakes are not operating correctly and must be repaired before the vehicle is returned to service.
See Group 42 of the Heavy-Duty Trucks Service Manual for repair procedures. Brake Component Inspection 5. Start the engine and build air pressure to at least 100 psi (689 kPa). Shut down the engine. 1. Park the vehicle on a level surface, set the park- ing brake, and chock the tires. Once the tires are chocked, release the parking brake. 6. Check all of the foundation brake components for damage, wear, and loose or missing parts. Re- pair as needed. See Group 42 of the Heavy- Duty Trucks Service Manual for repair proce- dures. WARNING Manually adjusting an automatic slack adjuster to bring the pushrod stroke within legal limits is Heavy-Duty Trucks Maintenance Manual, October 2009 42/14