Steering 46 poid gear oil API service classification GL–5 (with no zinc additive). At operating temperatures con- tinuously above 30°F use viscosity grade SAE 90. At operating temperatures continuously below 30°F use viscosity grade SAE 75. 3. Install and tighten the fill plug 14 lbf·ft (19 N·m). 46–04 Drag Link and Power Steering Cylinder Lubricating f460007a 1 05/28/93 1. Slip Joint Grease Fitting Fig. 3, Steering Driveline Slip Joint 1. Using a clean rag, wipe all dirt from both drag link grease fittings, and if so equipped, both power steering cylinder grease fittings. See Fig. 5 , Fig. 6 , and Fig. 7 . 1 6 5 2 4 2 1 2 05/28/93 3 1. Grease Fitting Fig.
5, Drag Link (pitman arm end) f460044 05/28/93 1. Fill Plug 2. Steering Gear Attachment Fasteners 3. Drain Plug 4. Pitman Arm Pinch Bolt and Nut 5. Input Shaft End Yoke Pinch Bolt and Nut 6. Input Shaft End Yoke U-Joint Grease Fitting 2. Using a pressure gun, apply clean grease at the grease fittings until old grease is forced out of the socket. Use multipurpose chassis grease NLGI grade 2 (8% 12-hydroxy lithium stearate grease) or NLGI grade 1 (6% 12-hydroxy lithium stearate grease). Grade 2 is preferred. Fig. 4, TRW Model 503 Manual Steering Gear 46–05 Power Steering Reservoir Fluid Level Checking WARNING Use only an approved lubricant.
Failure to fill the steering gear with approved lubricant could ad- versely affect steering ease under certain condi- tions and could hamper vehicle control. This could lead to an accident resulting in injury or property damage. WARNING Failure to keep the power steering reservoir full could result in damage to the power steering pump and improper operation of the power steer- ing system. 2. Fill the steering gear with clean lubricant to within 1/2 inch (13 mm) of the fill hole. Use hy- Heavy-Duty Trucks Maintenance Manual, November 2002 46/2