Steering 46 1 2 3 4 5 05/28/93 f460012 f460010a 1 1. Dipstick T-Handle 2. Thumbscrew 3. Hose Fitting 4. Gear-to-Reservoir Return Hose 5. Reservoir-to-Pump Supply Hose 05/28/93 1. Grease Fitting Fig. 6, Drag Link (axle steering arm end) Fig. 8, 2-Quart Power Steering Reservoir, 2-Line (typical) WARNING Fill only with approved clean fluid. Failure to use the proper fluid could cause seal deterioration and leaks. Fluid leaks could eventually cause loss of power steering assist. This could lead to an acci- dent resulting in personal injury or property dam- age. Wear eye protection when changing the fluid and filter. 2.
With the power steering fluid at operating tem- perature, check the fluid level on the dipstick. If low, add enough fluid to bring the level up to the full mark on the dipstick. See Table 1 for ap- proved power steering fluid. 1 3. Install the dipstick (fill cap) in the power steering reservoir. 05/28/93 f460048 1. Grease Fitting (axle steering arm end) Fig. 7, Power Steering Cylinder 46–06 Power Steering Reservoir Fluid and Filter Changing 1. Clean around the power steering reservoir dip- stick (fill cap) with a clean rag. Then remove the dipstick (fill cap). See Fig. 8 . 1. For a 2-quart or a 4-quart power steering reser- voir, remove the dipstick, thumbscrew or cover capscrew, and cover.
See Fig. 8 . Heavy-Duty Trucks Maintenance Manual, November 2002 46/3