Frame and Fifth Wheel 31 A 1 2 3 5 1 4 2 3 11/28/95 f310353b 4 1. Lubricant Grooves 2. Safety Latch 3. Lock Control Handle 4. Mount f310475 08/31/95 A. Extended Top Plate Lift Height 1. Fifth Wheel Top Plate 2. Fifth Wheel Frame Mount 3. Frame Rail 4. Lifting Point 5. Static Top Plate Height Fig. 3, Simplex Series Fifth Wheel 1 NOTE: Do not measure plate lift immediately after a trailer has been uncoupled from the fifth wheel. The rubber may have taken a temporary set, which will normally recover after being un- coupled for a short period of time. Fig. 5, Measuring Fifth Wheel Top Plate Lift 8. Check all mounting bolts for signs of fatigue, and tighten them to the proper torque.
For torque specifications, see Group 00 of this manual. In- spect all angles, plates, and brackets for cracks or other damage. 2 9. Replace cracked, worn, or damaged parts with new parts. Replace all loose mounting bolts with 5/8–11 SAE grade 8 bolts, grade C locknuts, and hardened washers. Do not re-use bolts, nuts, and washers on fifth wheel mountings. 09/15/95 f310470 1. Operating Handle 2. Lever Bar Fig. 4, Lever Bar and Operating Handle Alignment frame rail to the top of the fifth wheel plate (Ref. 1). Pry up on the fifth wheel plate (Ref. 4) below the pin boss, and measure the vertical move- ment (Ref. 5).
The bracket connection provides a 9/32-inch (7-mm) vertical clearance to provide cushioning and to avoid downward pin-loading while retaining minimum plate lift. If the plate lift (Ref. A) exceeds 5/16 inch (8 mm) as a result of wear or rubber deterioration, install new, stan- dard or oversized bracket-shoe rubber pads; see Group 31 of the Heavy-Duty Trucks Service Manual for replacement instructions. 10. After inspecting the fifth wheel, lubricate all mov- ing parts with a chassis or multipurpose grease. See Maintenance Operation 31–02 for lubrica- tion instructions. ASF Touchloc Control Mechanism General Inspection 1. Replace cracked, broken, bent, or missing parts with new parts. See Fig.
6 . 2. The cotter pin located in the slide cam clevis pin must be in place and properly spread. Heavy-Duty Trucks Maintenance Manual, October 2009 31/4