Frame and Fifth Wheel 31 1 4 1 2 3 09/12/96 f310549 1. Cotter Pin 2. Locknut 3. Mounting Bolts 4. Slide Cam Fig. 6, Touchloc Control Mechanism General Inspection 10/17/96 1. Extension Spring f310548 3. The locknut that attaches the air cylinder to the housing weldment must be tight, but should not distort the cylinder clevis legs inward. Fig. 7, Touchloc Control Mechanism Lubrication 8. Cycle the slide cam several times to ensure smooth operation. 4. Check all mounting bolts for tightness. NOTE: A sluggish slide cam may be improved by spraying the slide cam, track, and inside of the rectangular slide cam housing with a prod- uct such as light oil, silicon lube, or equivalent. 9.
Lubricate the air mechanism unit each time the tractor is steam cleaned. ASF Touchloc Control Mechanism Component Inspections ASF Touchloc Control Mechanism Lubrication 1. Thoroughly inspect the air cylinder ( Fig. 8 ). It must retract and extend throughout the operating range without any interruption of piston travel. 1. With the air cylinder and the slide cam in the re- tracted position, lubricate the cam track with a light oil-type lubricant. See Fig. 7 . The air cylinder is in satisfactory working order upon completion of six consecutive extensions and retractions at 90 to 120 psi standard operat- ing pressure. 2.
If the operating rod plate casting track is rusted, apply penetrating oil (with teflon) to remove the rust. Apply white lithium grease into the track. If the air cylinder does not function properly, re- move the air cylinder. Manually extend the piston to its maximum length, and retract fully. Any bind- ing of the piston requires reconditioning or replacement. 3. Remove the extension spring for easy access. 4. Activate the cab control valve, moving the oper- ating rod into lockset (unlocked mode) position. 5. Lubricate the slide cam shaft. 2. Inspect the slide cam and housing for any warpage, damage, or cracks. If any cracks are found, replace the components. 6.
Spray lubricant into the rectangular slide cam housing. 7. Replace the extension spring. 3. Check the return spring for overextension, abra- sion, and a rust-deteriorating condition which would require replacement. Heavy-Duty Trucks Maintenance Manual, October 2009 31/5