. MAINTENANCE MAINTENANCE PROCEDURE How to Remove Slinging Loop WARNING In case a slinging loop is fitted to the bucket tooth, remove it. If digging work is started without the slinging loop being removed, there is the danger that the slinging loop is broken and broken pieces are sent 1. Put block (3) under the bottom of the bucket and stop the engine. 4 - 31 flying a It is quit while th Hold the and put round. e dangerous if the work equipment begins to move by mistake e slinging loop is being removed. work equipment in a steady and safe posture; stop the engine; the lock lever in the "LOCK" position.
he slinging loop is being removed, there is the danger that While t he slinging loop is being rem broken slinging loop pieces are sent fly ing around, so wear protective tools su ch as safety glasses. Never h it the tooth against a boulder f or the purpose of removing the slinging loop. the danger that the broken slinging loop will be sent flying in pieces, causing a personal injury.
There is around in pieces, causing a personal in NOTICE If the mach ine is operated without the slin g being removed, the following problems may possibly ari When th e work equipment is pulled bac k, the slinging loop at the tip of the tooth interferes with th A crack occurring at the time of sling b reakage progresses to the tooth , resulting in the breakage The slin g is broken in the digging oper ation, broken pieces are mixed i n the sand and earth to be Be sure to remove the slinging loop in the following steps. 2.
Withi n 15 seconds after stoppin g the engine, move each contr in all ol lever (for work equipment and travel) to the full stroke directions to release the inte rnal pressure. 3. Chec k that the work equipment is i n a stable condition, then set the lo ck lever to the LOCK positio n (L).