Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE cutter to cut the slinging. Tip of tooth (1) Top of tooth (2) NOTICE When cutting the slinging loop at each 4 - 32 4. Preheat the slinging loop to b e cut to 100-15 0 oC and use a g as cut the B), according to the shap e of following cutting p the loop. In a ddition, when doing this, be care ful that the cutting surface does not cut into the main b ody of the bucket Cutting positio This applies t o tip of tooth (1). Cut at the bot tom of the hole i n the lifting loo Cutting positio n (B) - (B) o top of tooth (2).

t This applies t o top of tooth (2) Cut at a positi on 10-20 mm (0 .4 - 0.8 in) from the mai n body of he bucket pa rt. 5. Finish the cu tting surface sm oothly, using a grinding machine 6. Check that t here is no crack on the cutting