Komatsu — EVERY 500 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE fuel or oil, then install it to ( 0.02 -0.046 kgm, 0.1 - 0.3 10. Clean the filter holder, fill the new filter cartridge with clean fuel, coat the packing surface thinly with oil, then install to the filter holder. 4 - 51 6. Remove seal (4) from transpar 7. If transparent cap (3) is dama Coat new seal (4) with clea transparent cap (3). 8. Install transparent cap (3) to n Tightening torque for transp 10.0 Nm (1.0 kgm, 7.2 lbft) Tightening torque for transp 9. Check that the drain plug at th is tightened securely. Tightening torque: 0.2 - 0.45N lbft) NOTICE When adding fuel, do not remove c small holes (A) on the dirty side.

After adding fuel, remove cap (B) a Always fill with clean fuel. Be caref the fuel. In particular, center portion cap (B) when adding fuel. Be careful portion on the clean side. 11. When installing, tighten until th e packing surface contacts the seal surface of the filter holder, then tighten it 3/4 of a turn. If the filter cartridge is tightene d too far, the packing will be damaged and this will lead to leakage of fuel. If the filter cartridge is too loose, fue l will also leak from the packing, so always tighten the c orrect amount. When tightening with a filter wrench, be extremely careful not t o dent or damage th 12. Turner valve (1) at the bottom 13. it.

After replacing the filter cartrid low idling for 10 minutes. Check for leakage of oil from t leaking, check the tightening of oil leakage, repeat Steps 1 - 5 t if any damage or embedded surface is found, replace it w Steps 6 - 13 to install it.