Suspension 32 4. Inspect the V-rods and lower control rods for wear and looseness. NOTICE 4.1 Without disconnecting the control rods, use your hand to attempt to move each of the control rod ends up, down, in, and out. If there is any movement, examine the control rods for wear or damage. Re- place if necessary. When removing or loosening a Barksdale height- control valve from a mounting bracket, always hold the valve-side mounting studs in place with an Allen wrench while loosening or tightening the nuts that attach the valve to the bracket.
Because the mounting studs are threaded into the valve body, loosening the nuts without holding the studs can tighten the studs, which can crush the valve body and damage the valve. Conversely, tightening the nuts without holding the studs can back the studs out, causing a separation of the two halves of the valve body, and possibly a leak. 4.2 Inspect the rubber bushings for cracks or cuts. 4.3 Check for any shifting of the barpin. 4.4 Check for cracks in the metal compo- nents and welds. 5. Check all fasteners for looseness. 1. Inspect the fasteners that attach the suspension brackets to the frame for proper torque. See Group 00 for bolt torque specifications. 6.
Inspect the shock absorbers for oil leaks and worn rubber bushings. Replace the shock ab- sorbers and/or rubber bushings if wear or dam- age is noted. AirLiner Suspension WARNING Be sure that the fasteners are torqued correctly. Fasteners that are not tight can cause separation of components or premature failure of compo- nents, loss of vehicle control and possible per- sonal injury or property damage. WARNING Do not replace individual leaves of a damaged leaf spring assembly; replace the complete spring as- sembly. Visible damage (cracks or breaks) to one leaf causes hidden damage to other leaves. Re- placement of only the visibly damaged part(s) is no assurance that the spring is safe.
On front spring assemblies, if cracks or breaks exist in the two top leaves, a loss of vehicle control could occur. Failure to replace a damaged spring assem- bly could cause an accident resulting in property damage, serious personal injury, or death. 2. Inspect the forward and rear spring brackets for wear, cracks, and other damage. If any of these conditions exist, replace the damaged bracket(s). WARNING Replace worn, cracked, or damaged spring brackets. Failure to do so could result in bracket breakage, possibly leading to loss of vehicle con- trol and resulting in personal injury or property damage. IMPORTANT:
To prevent voiding the warranty on Barksdale height-control valves, note the fol- lowing: 3. Inspect the crossmember(s) and gussets for wear, cracks, and other damage. If any of these conditions exist, replace the damaged parts. Do not overtighten the bolts in the Barksdale height-control valve housing. The bolts should not be loose, and should not require tightening. Only if necessary, tighten the valve housing bolts 45 lbf·in (500 N·cm). Any damage to the valve housing will void the warranty. 4. Visually check the air spring piston for cracks, chips, and broken areas. Check the air bag for rips, tears, and holes. Verify that the air spring assembly does not leak.
Do not attempt to disassemble the Barksdale valve body or the control lever. There are no serviceable parts in the valve, and any disas- sembly will void the warranty. WARNING If damaged air bags are found, do not continue to use the vehicle, take the vehicle to your Western Star dealer to have the air bags replaced because Western Star Maintenance Manual, September 2015 32/4