Suspension 32 the sudden loss of air bag pressure can cause loss of vehicle control resulting in serious per- sonal injury and property damage. 1 IMPORTANT: Before checking the AirLiner sus- pension height, make sure there is no load on the chassis, and the trailer is unhitched. 5. Park the vehicle on a level surface, using a light application of the brakes. Do not apply the park- ing brakes. Shift the transmission into neutral, and build the secondary air pressure to at least 100 psi (690 kPa). Shut down the engine. A 6. Mark the location of the front and rear tires on the floor, and chock the tires on one axle only. 7.
On single-drive rear axle configurations, measure the distance from the bottom of the left axle stop to the top of the U-bolt pad. On dual-drive rear axle configurations, measure the distance from the bottom of the forwardmost left axle stop to the top of the axle U-bolt pad. See Fig. 7 , Ref. A. The correct distance for single and dual-drive rear axles is from 2-3/8 to 2-7/8 inches (60 to 73 mm). 08/16/96 f320453 8. If the axle stop measurement is not correct, con- tact your Western Star dealer to adjust the level- ing valves. A. Measure height here. 1. Left Forwardmost Axle Stop 9. Check the shock absorbers.
For instructions, see Maintenance Operation 32-01 , "Suspension Inspection." Chalmers Suspension Fig. 7, AirLiner Axle Stop Measurement 2. Chock the front tires to prevent the vehicle from moving. Place the transmission in neutral, and release the parking brakes before inspecting the Chalmers rear suspension. WARNING 3. Power-wash the Chalmers rear suspension, or clean it with a hard-bristle brush before perform- ing a visual inspection. Before making any inspections, always make sure that the vehicle’s park brake is set and that the wheels are chocked to prevent accidental vehicle movement to prevent serious injury. 4. Visually inspect the rubber bushings for cracks or other damage. 1.
Inspect the fasteners that attach the suspension brackets to the frame for proper torque. See Group 00 for bolt torque specifications. Try to move the torque rod ends using your hands only, and check for any free-play. If free- play is felt, replace the torque rod end bushing. Do not use a pry bar to check for free-play. Use of a pry bar may lead to premature bushing re- placement. WARNING Be sure that the fasteners are torqued correctly. Fasteners that are not tight can cause separation of components or premature failure of compo- nents, loss of vehicle control and possible per- sonal injury or property damage. 5. Visually inspect the walking beam for cracks or other damage.
If damage is found, replace the walking beam. 6. Visually inspect the restrictor cans for cracks, severe corrosion, and distortion. If any of these Western Star Maintenance Manual, September 2015 32/5