4M41 ENGINE - Injection Pump Assembly 11B-12-2 REMOVAL SERVICE POINT A A " INJECTION PIPE REMOVAL Loosen the union nut B of the fuel injection pipe 13 while locking the delivery valve holder A to prevent it from rotating together. A B 13 INSTALLATION SERVICE POINTS " A A INJECTION PUMP ASSEMBLY INSTALLATION (1) Turn the crankshaft pulley A clockwise with the specified special tool to place the No.1 piston at the TDC on the compression stroke. Align the notch C in the crankshaft pulley with the timing mark 0 on the timing gear case B . A B MB990767 MD998754 C MB990767 A D Caution 1. If the dent D on the camshaft faces upward, the No.1 piston is at the TDC on the compression stroke.
If not, rotate the crankshaft pulley A one more turn in normal direction. 2. Never rotate the crankshaft pulley A in reverse direction (counterclockwise). It may cause damage to the timing chain tensioner. If the crankshaft is accidentally rotated in reverse direction, remove and reinstall the tensioner according to the correct installation procedure. G (2) Align the notch F on the injection pump gear E with the mating mark H on the flange plate G . E F H 4ME0542 (3) Align the guide bar J of the flange plate G with the guide hole L of the front plate K and insert the injection pump assembly into the front plate just before the injection pump gear E meshes with the idler gear.
L J E K G 4ME0543 PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added