PACCAR 579, 567 — Anti-Lock Brake Systems (ABS)

DRIVING - Brakes Trailer ABS Power Line Communication (PLC) WARNING NOTE Do not rely on an anti-lock brake sys- tem that is functioning improperly. You could lose control of the vehicle result- ing in a severe accident, causing death or personal injury. If your ABS lamp goes on while you are driving or stays on after the self-check, your anti- lock system might not be working. The ABS may not function in an emergen- cy. You will still have conventional brakes, but not anti-lock brakes. If the lamp indicates a problem, have the ABS checked. North American on-highway vehicles are equipped with a separate electrical circuit to power the anti-lock brake system (ABS) on towed vehicle(s).

In most cases, the ABS power will be supplied through the Auxiliary circuit on the primary 7-way trailer light line connector. If the vehicle was manufactured with a switchable Auxiliary circuit for trailer accessories, an additional 7-way connector would have been provided for trailer ABS power. In either case, the ABS power line on the vehicle will be PLC equipped. Tractors/Trucks and trailers built after 03/01/2001 must be able to turn on an In-Cab Trailer ABS Warning Lamp (per U.S. FMVSS121). The industry chose Power Line Communication (PLC) as the standard method to turn it on.

On trailers built prior to 03/01/2001 verify trailer ABS system status via the re- quired external warning lamp mounted on the trailer. The indicator lamp on the trailer should be yellow and identi- fied with the letters ABS. 4 For doubles or triples, the lamp does not distinguish between trailers. An ABS problem in any of the trailers will activate the Trailer ABS Warning Lamp.

If you change the intended service in any way (e.g., number of axles, multiple trailers, add switchable trailer accessories, etc.) from the date the vehicle was manufactured, you should contact your trailer manufacturer and/or trailer anti-lock brake manufacturer to determine if the power available at the 7-way trailer light line is adequate. Failure to do so might result in insufficient power to the trailer Vehicles without anti-lock brake systems (ABS) are typically equipped with a bobtail brake proportioning system. When a trailer is not connected, the drive axle brake application pressure will automatically be limited by the proportioning system.

When driven in a bobtail mode, these tractors will require greater brake pedal application to provide the equivalent braking to a bobtail tractor not equipped with a proportioning system. CAUTION DO NOT splice into the non-switchable Auxiliary circuit on the primary 7-way trailer light line. Doing so may cause the trailer ABS to malfunction. This cir- cuit is dedicated for trailer ABS power. To add a switchable auxiliary circuit, contact a dealership. Y53-6047-2HEN (03/18) 149