DRIVING - Axle and Suspension and the axle is in its up position. Axle creep ratings are assigned by the axle manufacturer and are based on axle model and intended service of the vehicle. Contact an authorized dealership if you are unable to identify the axle creep rating of this vehicle. Liftable/steerable (axle lift calibration required) Liftable/non-steerable (axle lift calibration required) Non-liftable (some suspensions require dump valve calibration) Related concepts pusher or tag axle, load will be transferred to drive axles. Do not overload drive axles. Always deflate air springs of the auxiliary axles before attempting to unload vehicle.
This allows maximum traction of the drive axles to control the vehicle. Depending on the suspension, various calibrations may be required. Contact your authorized dealer or axle/suspension manufacturer for specific calibration procedures. Some suspensions require dump valve calibration. For example, some dead axles do not lift, but the air can be dumped out of them to unload them when empty. Air pressure is controlled via an adjustable regulator. These axles need to be calibrated for load. Contact your authorized dealer or axle/ suspension manufacturer for dump valve calibration procedures. Auxiliary Axle Pressure Regulator Information on using the auxiliary axle pressure regulator.
Vehicles with liftable auxiliary axles will have knobs available to adjust the pressure in the auxiliary axle suspension. These knobs are in addition to the tag and pusher axle switches that control the axle position. Adding more pressure to the auxiliary axle will increase the pressure the auxiliary axle pushes down. Increasing pressure will decrease load on the drive axles and will descrease traction. Decreasing pressure will transfer more weight to the drive axles and will result in more traction from the drive axles. Deflate the auxiliary axle suspension before coupling or uncoupling a trailer.
After the trailer is coupled or de-coupled, then increase pressure to balance traction and axle load requirements. Inflate air springs of the auxiliary axles to the desired pressure after coupling to a loaded trailer while still maintaining proper traction of the drive axles. Adjust the pressure regulator control knob to a lower pressure until desired traction is obtained. By reducing air pressure at 4 WARNING Do not operate or park the vehicle with auxiliary axles in the down/ loaded po- sition when vehicle is unladen, or is being unloaded. Raise or dump air into driver controlled auxiliary axle(s) prior to unloading vehicle.
Failure to do so can result in loss of vehicle control or rollaway that may result in death, per- sonal injury, equipment or property damage. What is Axle Creep Rating Vehicles outfitted with auxiliary axles, and full truck configuration, will have an axle creep rating which defines how much load is allowed when the vehicle has a full load and manuevering the vehicle, at very slow speeds, with auxiliary axles in the up position. In these situations, the load Y53-6047-2HEN (03/18) 159