hitachi — Hitachi ZX14-3/ZX16-3/ZX18-3/ZX27-3 Hydraulic Excavator Operator's Manual

OPERATING MACHINE Blade and Track Width Control Lever Operation (ZX18-3) 1 2 3 d CAUTION: Be sure to set the track width to either 1280 mm (fully extended) or 970 mm (fully retracted). If the machine is operated with the track width set to a dimension other than 1280 mm or 970 mm, the track width will not be secured so that the machine upper structure will move unstably. Track-width control switch Never attempt to adjust the track width on a slope. Failure to follow these instructions will cause the machine to turn over or skid, possibly resulting in personal injury. ZX18-3(Canopy) M1NC-05-014 IMPORTANT: • Check the sliding surfaces on the track frame for any accumulated debris.

If any debris such as soil has accumulated, remove the accumulated debris and clean the surfaces. • Check the ground surface under the machine. In case the surface is not flat or if any protruding obstructions exist, move the machine to a flat surface area or remove the obstruction before adjusting the track width. • Do not use the track width control function to move or tow any objects. Machine failure or damage may result. SS4706712 2 3 1 Track-width control switch M1NC-04-003 ZX18-3(Cab) Blade (When the track-width control switch is OFF:) Use lever (1) to raise and lower the blade.

When the lever is released, it automatically returns to its neutral position, keeping the blade in its position until the lever is operated again. (2) Blade raise (3) Blade lower 2 Track width (When the track-width control switch is ON:) Use lever (1) to change the width of the track (under carriage). When the lever is released, it automatically returns to its neutral position, keeping the width in its position until the lever is operated again. (2) Narrow width (3) Extend width 3 M1NC-04-001 2 3 M1NC-05-015 5-6