OPERATING MACHINE Extending / Retracting Blade Width (ZX18-3) Change the blade width in accordance with the side frame extension / retraction. When working with the blade contact to ground, there are some cases that it is difficult to remove the pins. Work after raising the blade, and stopping the engine. 5 When Extending the Blade Width: 1. Remove blade pins (5). 2. Turn over the extension blade (4) and align the two pin holes. 3. Install blade pins (5). 4. Extend the left side following steps 1 to 3 above. 4 M1MS-05-008 When Retracting the Blade Width: 5 1. Remove blade pins (5). 4 2. Turn over the extension blade (4) so that the cutting edge side may turn to the track shoe side.
Align the two pin holes. 3. Install blade pins (5). 4. Retract the left side following steps 1 to 3 above. M1MS-05-009 5-7