MAINTENANCE Maintenance Guide A. Greasing (See Page 7-15) f NOTE: Grease all submerged pins after operating in water. Grease all pins daily during break-in operation for 50 hours. Grease all pins every 100 hours only during first time operation up to 500 hours. B. Engine (See Page 7-21) f NOTE: The oil life is shortened more than normal under high temperature operating, shorten the maintenance interval. C. Transmission (See Page 7-24) D. Hydraulic System (See Page 7-27) f NOTE: Hydraulic oil changing intervals differ according to kind of hydraulic oils used. See recommended oil chart. For the first time only. 7-9 Parts Quantity Interval (hours) 8 50 100 250 500 1000 2000 1.
Front Joint Pins (Incl. around the swing post) 9 ★ ★★ 2. Bucket and Link Pins 5 ★ 3. Blade Pins (ZX27-3 Only) 4 4. Swing Bearing 1 5. Swing Internal Gear 1 6. Control Lever Universal Joint 2 Parts Quantity Intervals (hours) 8 50 100 250 500 1000 2000 1. Engine oil Oil Level Check – Change ZX14-3, 16-3, 18-3 3.1 L ★ ZX27-3 6.2 L ★ 2. Replacement of Engine Oil Filter 1 Parts Quantity Interval (hours) 8 50 100 250 500 1000 2000 1. Travel Reduction Gear Oil Level Check – Change ZX14-3, 16-3, 18-3 0.25 L ×2 ZX27-3 0.5 L ×2 Parts Quantity Interval (hours) 8 50 100 250 500 1000 2000 1. Check Hydraulic Oil Level 1 2. Drain Hydraulic Oil Tank Sump 1 3.
Change Hydraulic Oil ZX14-3, 16-3, 18-3 30 L ★ ★ ZX27-3 56 L ★ ★ 4. Clean Suction Filter 1 When changing hydraulic oil 5. Replace Full Flow Filter Element 1 ★★ 6. Replace Pilot Filter Element 1 7. Check Hoses and Lines for leaks or looseness – for cracks, bend, etc. –