Yamaha Grizzly 660 — Yamaha Grizzly 660 User Manual

BLEEDING THE HYDRAULIC BRAKE SYSTEM 1.Bleed: Brake system ***************************************************** Air bleeding steps: a. Add the proper brake fluid to the reservoir. b. Install the diaphragm. Be careful not to spill any fluid or allow the reservoir to overflow. c. Connect the clear plastic hose 1 tightly to the caliper bleed screw 2 . И Front Й Rear d. Place the other end of the hose into a con- tainer. e. Slowly apply the brake lever or pedal sev- eral times. f. Pull the lever in or push down on the pedal and hold it. g. Loosen the bleed screw and allow the lever or pedal to travel towards its limit. h.

Tighten the bleed screw when the lever or pedal limit has been reached, then release the lever or pedal. i. Repeat steps (e) to (h) until all the air bub- bles have disappeared from the fluid. j. Tighten the bleed screw. NOTE: If bleeding is difficult, it may be necessary to let the brake fluid settle for a few hours. Repeat the bleeding procedure when the tiny bubbles in the system have disappeared. k. Add brake fluid to the proper level. Refer to “CHECKING THE BRAKE FLUID LEVEL”. WARNING Check the operation of the brake after bleeding the brake system. ***************************************************** 3 - 45 CHK ADJ CHK ADJ È É R. T. Bleed screw: 6 Nm (0.6 m • kg, 4.3 ft • lb)