ADJUSTING THE SELECT LEVER CONTROL CABLE AND SHIFT ROD 1 NEUTRAL 2 HIGH 3 LOW 4 REVERSE 5 PARK 6 Control cable 7 Select lever shift rod WARNING Before moving the select lever, bring the machine to a complete stop and return the throttle lever to its closed position. Other- wise the transmission may be damaged. 1.Adjust: Rear brake pedal free play Refer to “ADJUSTING THE REAR BRAKE”. 2.Adjust: Select lever control cable Select lever shift rod ***************************************************** Adjustment steps: Control cable: Make sure the select lever is in NEUTRAL. Adjust the control cable so there is zero free play in the cable.
When the adjustment is correct, slack in the return spring 1 will be taken up. NOTE: In some cases it will be necessary to further adjust the cable with the locknuts 2 arrange- ment that holds the cable to its mount. When the brake begins to work “ a = 25 ~ 40 mm (1.0 ~ 1.6 in)”, verify that the select lever can be shifted to REVERSE from NEU- TRAL, to PARK from REVERSE and to NEUTRAL from REVERSE. Before the brake begins to work “ a = 0 ~ 25 mm (0 ~ 1.0 in)”, verify that the select lever cannot be shifted to REVERSE from NEUTRAL, to REVERSE from PARK and to NEUTRAL from REVERSE. 3 - 46 ADJUSTING THE SELECT LEVER CONTROL CABLE AND SHIFT ROD CHK ADJ CHK ADJ