Yamaha Grizzly 660 — Yamaha Grizzly 660 User Manual

Charging method using a variable voltage charger NOTE: Measure the open-circuit voltage prior to charging. Leave the battery unused for more than 30 minutes before measuring its open-circuit voltage. Charger Ammeter NOTE: Set the charging voltage to 16 ~ 17 V. (If the charging voltage is lower, charging will be insufficient, if it is higher, the battery will be over- charged.) Connect a charger and ammeter to the battery and start charging. Is the amperage higher than the standard charging amperage written on the battery? NO YES Adjust the charging voltage to 20 ~ 25 V. Adjust the voltage to obtain the standard charging amperage. YES Monitor the amperage for 3 ~ 5 minutes.

Is the standard charging amperage exceeded? NO If the amperage does not exceed the standard charging amperage after 5 minutes, replace the battery. Set the timer to the charging time determined by the open- circuit voltage. Refer to “CHECKING THE BAT- TERY”. If the required charging time exceeds 5 hours, it is advisable to check the charging amperage after 5 hours. If there is any change in the amperage, readjust the voltage to obtain the standard charging amperage. Leave the battery unused for more than 30 minutes before measuring its open-circuit voltage. 12.8 V Charging is complete. 12.0 ~ 12.7 V Recharging is required. Under 12.0 V Replace the battery.

3 - 61 CHECKING THE BATTERY CHK ADJ CHK ADJ