MIDDLE GEAR To find shim thickness “B” use the following formula: Middle driven pinion gear shim thick- ness: e f + g h + i – 0.05 Where: e = a numeral (usually a decimal number) on the bearing housing is either added to or subtracted from “76”. f = a numeral (usually a decimal number) on the middle driven pinion gear is either added to or subtracted from “60”. g = a numeral (usually a decimal number) on the middle driven pinion gear is either added to or subtracted from “80.5”. h = a numeral (usually a decimal number) on the left crankcase specifies a thick- ness of “97.29”. i = a numeral (usually a decimal number) on the right crankcase specifies a thickness of “1.67”. Example:
1) If the bearing housing is marked “–06”, ..... e is 75.94. 2) If the driven pinion gear is marked “+0”, ..... f is 60.00. 3) If the driven pinion gear is marked “–13”, ..... g is 80.37. 4) If the crankcase (left) is marked “97.29”, ..... h is 97.29. 5) If the crankcase (right) is marked “1.67”, ..... i is 1.67. 6) Therefore, the shim thickness is 0.64 mm. B = 75.94 – 60.00 + 80.37 – 97.29 + 1.67 – 0.05 = 0.64 4 - 93 ENG