Yamaha Grizzly 660 — Yamaha Grizzly 660 User Manual

MIDDLE GEAR 5.Install: Universal joint ***************************************************** Installation steps: Install the opposite yoke into the U-joint. Apply wheel bearing grease to the bearings. Install the bearing 1 onto the yoke. CAUTION: Check each bearing. The needles can eas- ily fall out of their races. Slide the yoke back and forth on the bearings; the yoke will not go all the way onto a bearing if a needle is out of place. Press each bearing into the U-joint using a suitable socket. NOTE: The bearing must be inserted far enough into the U-joint so that the circlip can be installed. Install the circlips 2 into the groove of each bearing.

***************************************************** INSTALLING THE MIDDLE DRIVE SHAFT 1.Tighten: Nut (middle drive pinion gear) 1 New Secure the middle drive shaft in the vise with a clean rag. 2.Lock the threads with a drift punch. 4 - 96 ENG R. T. 145 Nm (14.5 m • kg, 105 ft • lb) NOTE: