Yamaha Grizzly 660 — Yamaha Grizzly 660 User Manual

***************************************************** Installation steps: Slide the shift fork sliding gear 1 , which is installed to the differential gear, to the left to put it into the 2WD mode. Connect two C size batteries to the gear motor terminal 2 to operate the pinion gear 3 , and operate it until the paint mark 4 on the gear is aligned with the paint mark 5 on the gear motor case. CAUTION: Do not use a 12 V battery to operate the pinion gear. Insert 8 mm bolts 6 into the gear motor 7 and use them as a guide to set the motor on the differential gear assembly 8 so that the shift fork sliding gear 9 does not move. CAUTION:

If the position of the shift fork sliding gear is moved, the position of the differential gear and the indicator light display may dif- fer, and the 2WD or differential lock mode may not be activated. Remove the 8 mm bolts, and then install the motor with the gear motor bolts. ***************************************************** 3.Install: Universal joint yoke O-ring Washer Nut Use a universal joint holder 1 . LT 7 - 13 FRONT CONSTANT VELOCITY JOINTS AND DIFFERENTIAL GEAR DRIV DRIV R. T. Bolts (gear motor) 13 Nm (1.3 m • kg, 9.4 ft • lb) R. T. 62 Nm (6.2 m • kg, 45 ft • lb) Universal joint holder: P/N. YM-04062, 90890-04062