Yamaha Grizzly 660 — Yamaha Grizzly 660 User Manual

FRONT CONSTANT VELOCITY JOINTS AND DIFFERENTIAL GEAR 4.Check: Differential gear operation Unsmooth operation Replace the differen- tial gear assembly. Insert the double off-set joint into the differ- ential gear, and turn the gear back and forth. INSTALLING THE UNIVERSAL JOINT 1.Install: Universal joint ***************************************************** Installation steps: Install the opposite yoke into the U-joint. Apply wheel bearing grease to the bearings. Install the bearing 1 onto the yoke. CAUTION: Check each bearing. The needles can eas- ily fall out of their races.

Slide the yoke back and forth on the bearings; the yoke will not go all the way onto a bearing if a needle is out of plate. Press each bearing into the U-joint using a suitable socket. NOTE: The bearing must be inserted far enough into the U-joint so that the circlip can be installed. Install the circlips 2 into the groove of each bearing. ***************************************************** 7 - 14 DRIV