FRONT CONSTANT VELOCITY JOINTS AND DIFFERENTIAL GEAR MEASURING AND ADJUSTING THE DIFFERENTIAL GEAR LASH Measuring the differential gear lash 1.Secure the gear case in a vise or another supporting device. 2.Remove: Drain plug Gasket 3.Install: A bolt of the specified size 1 (into the drain plug hole) CAUTION: Finger tighten the bolt until it holds the ring gear. Otherwise, the ring gear will be dam- aged. 4.Attach: Gear lash measurement tool 1 Dial gauge 2 a Measuring point is 21 mm (0.83 in) 5.Measure: Gear lash Gently rotate the gear coupling from engage- ment to engagement . Differential gear lash: 0.05 ~ 0.25 mm (0.0020 ~ 0.0098 in) NOTE: Measure the gear lash at four positions.
Rotate the shaft 90° each time. 7 - 15 DRIV DRIV Gear lash measurement tool: P/N. YM-01467, 90890-01467