CHECKING THE BULBS AND BULB SOCKETS WARNING Since the headlight bulb gets extremely hot, keep flammable products and your hands away from the bulb until it has cooled down. CAUTION: Be sure to hold the socket firmly when removing the bulb. Never pull the lead, otherwise it may be pulled out of the ter- minal in the coupler. Avoid touching the glass part of the head- light bulb to keep it free from oil, other- wise the transparency of the glass, the life of the bulb and the luminous flux will be adversely affected. If the headlight bulb gets soiled, thoroughly clean it with a cloth moistened with alcohol or lacquer thinner. 2.Check:
Bulb (for continuity) (with the pocket tester) No continuity Replace. NOTE: Before checking for continuity, set the pocket tester to “0” and to the “ ΩЧ 1” range. ***************************************************** a.Connect the tester positive probe to terminal 1 and the tester negative probe to terminal 2 , and check the continuity. b.Connect the tester positive probe to terminal 1 and the tester negative probe to terminal 3 , and check the continuity. c.If either of the readings indicate no continu- ity, replace the bulb. ***************************************************** 9 - 7 ELEC – + Pocket tester P/N. YU-03112, 90890-03112