Yamaha Grizzly 660 — Yamaha Grizzly 660 User Manual

IGNITION SYSTEM * C0NTINUITY Replace the ignition coil. * 9 - 12 ELEC – + 6.Ignition coil resistance Disconnect the ignition coil connector from ● the wire harness. Connect the pocket tester (Ω × 1) to the ● ignition coil. Tester (+) lead → Orange lead terminal Tester (–) lead → Ignition coil base Check that the primary coil has the speci- ● fied resistance. Primary coil resistance: 0.18 ~ 0.28 Ω at 20 °C (68 °F) Connect the pocket tester (Ω × 1k) to the ● ignition coil. OUT OF SPECIFICATION Tester (+) lead → Orange lead terminal Tester (–) lead → Spark plug lead Check that the secondary coil has the ● specified resistance. Secondary coil resistance:

6.32 ~ 9.48 kΩ at 20 °C (68 °F) BOTH MEET SPECIFICATION 7.Engine stop switch INCORRECT Refer to “CHECKING THE SWITCH”. CORRECT Replace the handlebar switch (left). Replace the handlebar switch (left).