volvo — page 70

Electrical system Check the 13- diodes in the opposite direction of current flow by switching the position of the positive and neg- ative probes. Carry out the same measurement proced- ure as above. NOTE! Check first the inner resistance in the measuring cables. When the measurement between the stator windings is carried out the measuring cable's inner re- sistance (e.g. 0.10 Q) must be deducted from the value obtained. The instrument should during this measurement show a one "1" (to far left). If the instrument shows another val- ue the diode is defective. Measure between all winding connections (three meas- urements). The resistance should lie at 0.10 S2. Note:

If any diode is defective the entire diode plate must be replaced. Measure also against the alternator material by con- necting the instrument in position S2. Measure between the respective winding and the material. The instrument should during this measurement show a one "1" (which i mplies infinite). Checking of the D+ diodes The diode plate's three magnetising diodes are check according to the same principle as above. I f the instrument shows another value the stator winding i s defective. Connect the measuring instrument's positive probe to the respective connection for the stator winding (1-2-3) and the instrument's negative probe to D+.

The voltage drop for the respective diode should be between 450 and 650 mV. Note: If any stator winding is defective the stator must be replaced as a complete unit. Check the D+ diodes in the opposite direction of current flow and switch the positions of the positive and nega- tive probes. Carry out the same measuring procedure as above. The instrument should show a one "1" (to far l eft). If the instrument shown another value the diode is defective. Starter motor General The stator motor is a DC series motor. The starter gear Note: If any diode is defective the entire diode plate must be replaced. i s controlled by a magnet and is moveable in an axial direction on the rotor shaft.

On engine MD2040 the starter motor is provided with a reduction gear. This enables a higher torque. Check measurement of the stator windings When the diode bridge is removed it is possible to measure the stator windings with the multimeter set to the "Buzzer" position. Measure the resistance between respective windings. 76