volvo — page 71

Electrical system Dismantling of the starter motor 1. Remove both battery leads. 2. Release the electric cables to the starter motor. 3. Dismantle the starter motor's attachment screws and lift off the starter motor. Stripping of the starter motor 1. Clean the exterior of the starter motor. Fig. 117. Dismantling of the stator housing 5. Remove the brush holder plate. Remove the stator housing from the rotor and front bearing shield; on 2040 from the gear housing. Fig. 115. Stripping of the starter motor Fig. 118. Dismantling of the rotor 2. Remove the magnet. 6. Remove the coupling arm and rotor. MD2040: The coupling arm is fitted in the gear housing. 3.

Remove the protective cover from the rear bearing shield. Remove the lock ring and where appropriate the intermediate washer(s). Fig. 119. Dismantling of the starter gear 7. Remove the starter gear as per Fig. 119. First re- move the lock ring by tapping down the contact ring with a suitable mandrel. Fig. 116. Dismantling of the bearing shield MD2040: The starter gear is fitted in the gear hous- i ng. 4. Remove the rear bearing shield. 77