volvo — page 72

Electrical system I nspection of the starter motor Assembly of the starter motor Troubleshooting on the starter motor should be handed over to an authorised electrical workshop which disposes over the necessary test equipment. Assembly is carried out in the reverse order to strip- ping. Connect + and - from a 12 V battery to the terminal on the magnet and check that the starter gear is pushed forward to the gear stop. 1. Test the rotor with respect to winding flash-over and failure with the test equipment for this purpose. Fitting of the starter motor 1. Place the starter motor in position in the flywheel housing and tighten it. 2. Connect the electric cables to the starter motor.

See the wiring diagram on page 80-86. 3. Connect both battery leads. Fig. 120. Checking of the commutator 2. Check that the mating surfaces for the electric brushes on the commutator are smooth and free from dirt and oil. If the commutator is damaged or burnt it can be polished with sandpaper No. 500 or 600. Electrical components Relay box with fuses Measure the commutator with a dial gauge. Max. permissible radial distortion is 0.05 mm (.0019 in). The A-version has two fuse blocks each with four fus- es (15A) for plus (+) and minus (-) placed on the relay box at left-hand rear side of the engine. 3.

Check that the commutator's insulation lies at least 0.2 mm (.0078 in) below the laminated surface. Cor- rect if necessary. See Fig. 120. The B/C-version has one fuse block. The fuses disconnect the current in the event of over- l oading. 4. Check the linearity of the rotor. Brace the rotor be- tween spikes and measure the radial distortion on the rotor frame with a dial gauge. Max. permissible radial distortion is 0.08 mm (.0031 in). Re-connect the electrical system of a fuse has blown by moving the cable connection to the next contact. Note: The radial distortion is half of the read value. 5. Check the cogs on the starter gear. Replace dam- aged gear.

Check also the starter gear ring if the gear is damaged. Check with a test instrument that there is no failure in the winding. If the field winding is defective it should be re- placed. Field winding Fig. 121. Relay box with fuses 1. Fuse block + (1 5A) 2. Starter relay 3. Glow relay 78