TESTING AND ADJUSTING TESTING AND ADJUSTING BRAKE PEDAL LINKAGE TESTING AND ADJUSTING BRAKE PEDAL LINKAGE Testing 1. Check for play in linkage mounting pin (1), pin hole of lever (2), and lever bushing. 2. Measure length of linkage X1 = 175 mm, and check that it is within the standard value. i Measure the length from the center of pin (1) to the center of ball joint (6a). 3. Measure the distance of movement of rod (8) and check that clearance a is within the standard value. i When doing this, check that the brake pedal is in contact with the stopper. Adjusting 1.
Adjusting link X1 1) Remove pin (1) and ball joint (6a), remove rod and loosen locknut (5), then turn yoke (6) and ball joint (6a) to adjust the length. 2) After adjusting the length of rod X1, connect it to the brake pedal. Standard values X1 = 175mm X2 = 154.3mm a = 0 - 0.7 20-32