Komatsu — TESTING AND ADJUSTING BRAKE PEDAL LINKAGE

TESTING AND ADJUSTING TESTING AND ADJUSTING BRAKE PEDAL LINKAGE 2. Adjusting rod X2 1) Loosen locknut (7), turn rod (8) so that tip C of rod contacts the master cylinder piston, then turn rod (8) back 1/4 turn. i Movement for Ѕ turn of rod: 0.75 mm 2) Tighten locknut (7) to hold in position. 3. Adjusting switches 1) Transmission cut-off switch (left pedal) Loosen mounting screw of switch (9) and adjust switch (9) so that protrusion b of the tip of the switch from the end face of the transmission cut-off switch plate is the standard value. i Dimension b : 1.1 - 1.9 mm i When doing this, check that the switch is ON.

To adjust the cut-off timing, adjust plate (10) so that the dimension d from the center of the stopper bolt of plate (10) to the end face of plate (10) is 27 mm. i When doing this, check that plate (10) contacts portion e of the switch plate. i Adjust with the pedal in the FREE condition. 2) Stop lamp switch (right pedal) Install with mounting nut (11) of stop lamp switch (12), and adjust. Install so that the tip of the switch is pushed in 3.5 - 5.0 mm. i Amount that tip of switch is pushed in: 3.5 - 5.0 mm When doing this, check that the switch is OFF. i Adjust with the pedal in the FREE. condition 20-33