TESTING AND ADJUSTING MEASURING BRAKE OIL PRESSURE MEASURING BRAKE OIL PRESSURE i Measurement conditions C Engine water temperature: Within white range on engine water temperature gauge C Brake pressure: 4.1 Mpa (42 kg/cm ) 2 Apply the parking brake and put blocks under the tires. Measuring 1. Raise the boom, set support ( 1A ) or tool Q in position, then remove front cover ( 1 ). 2. Stop the engine. i When leaving the operator’s seat, apply the lock to the work equipment control levers securely. 3. Remove brake tube ( 2 ) on the side to be measured, then remove adapter ( 3 ). 4. After removing the adapter, install BRAKE TEST KIT L1 , L2 . i Connect the quick coupler of tool L1 , L2 . 5.
Loosen bleeder screw ( 4 ) and bleed the air. i Operate pump г to bleed the air. 6. Tighten the bladder screw, operate pump г , raise the pressure to 4.1 Mpa (42 kg/cm ), then tighten stop valve д . 2 7. After applying the pressue, leave for 5 minutes and measure the drop in the pressure. i If the hose is moved while measuring the pressure, the pressure will change, so do not move the hose. i When removing BRAKE TEST KIT L1 , L2 after testing, operate pump г to lower the pressure of L1 , L2 , then remove it. i After completing the operation, install the brake tube, then bleed the air from the brake circuit. 20-35