Komatsu — MEASURING WORK EQUIPMENT HYDRAULIC PRESSURE

TESTING AND ADJUSTING MEASURING WORK EQUIPMENT HYDRAULIC PRESSURE MEASURING WORK EQUIPMENT HYDRAULIC PRESSURE i Measurement conditions C Engine water temperature: Within white range on engine water temperature gauge C Hydraulic oil temperature: 45 - 55 E C (113 - 131 E F) C Engine speed: High idling Work equipment relief valve pressure measuring procedure Loosen the oil filler cap slowly to release the pressure inside the hydraulic tank. Then operate the control levers several times to release the remaining pressure in the hydraulic piping. 1. Remove plug (1) for measuring the hydraulic pressure in the bucket cylinder circuit. 2.

Install tool C1 (39.2 Mpa (400 kg/cm )) to the measurement 2 port. i Check that there is no oil leakage from any joints. i Use a hose which is long enough to reach the operator’s compartment. 3. Start the engine, raise the boom about 400 mm, run the engine at high idling, then operate the control lever to tilt back the bucket, and measure the pressure when the relief valve is actuated. i Be careful not to apply any sudden pressure to the pressure gauge. When removing the hydraulic pressure gauge, release the pressure inside the circuit in the same way as when it was installed. 20-46