TESTING AND ADJUSTING MEASURING WORK EQUIPMENT HYDRAULIC PRESSURE Adjusting Always stop the engine when adjusting the oil pressure. 1 . Raise the boom, set support (1A) or tool Q in position, then remove front cover (1). 2 . Remove cap nut (2) of relief valve (5). 3 . Loosen lock nut (3), then turn adjust screw (4) to adjust. i Pressure adjustment for one turn of adjustment screw: Approx. 2.43 Mpa (2.43 kg/cm ) 2 i Turn the adjustment screw to adjust the set pressure as follows. TIGHTEN to INCREASE pressure LOOSEN to DECREASE pressure i Do not carry out any adjustment if the relief pressure cannot be measured accurately. 20-47