DISASSEMBLY AND ASSEMBLY ALTERNATOR ALTERNATOR Warning! Stop the machine on level ground and install the safety bar on the frame. Lower the bucket to the ground and stop the engine. Then apply the parking brake and put blocks under the wheels to prevent the machine from moving. Warning! Disconnect the cable from the negative (-) terminal of the battery. REMOVAL 1. Disconnect negative (-) terminal (1) of the battery located behind the radiator grille. 2. Open engine hood side cover and lock into position. 3. Remove 5 mounting bolts of left fan guard half (2) and rotate down out of way. 4. Install 3/8" drive breaker bar (3) in belt tensioner.
Lift up on breaker bar and remove belt (4) from alternator pulley. 5. Remove output (5) and ground (6) leads from back of alternator. 6. Remove bottom mounting bolt (7). Supporting the alternator, remove top mounting bolt (8) and remove the alternator from the machine. INSTALLATION Ъ Install starting motor assembly in reverse order of removal Mounting bolt: 32 ±4 lbf.ft (43 ±6 Nm) (4.38 ±0.61 kgm) 30-12 WA250-3L