DISASSEMBLY AND ASSEMBLY TRANSMISSION 4. Parking brake assembly 1) Assemble gasket to parking brake retainer assembly (33). 2) Raise housing and piston assembly (33-1) and install to parking brake retainer. Ъ Be careful not to damage the oil seal retainer portion when assembling. Mounting bolt: 110.3 ± 12.3 Nm (11.25 ± 1.25 kgm) 3) Remove guide pin (44-1), then assemble mounting bolts (48) and tighten bolts uniformly. Ъ The length of the mounting bolts is different. The lengths are as follows. (48-1) = 35 mm (48-2) = 50 mm (48-3) = 60 mm (48-4) = 75 mm 4) Remove lock set bolt (49) and assemble plug.
5) Coat lip of oil seal (28) thinly with grease and assemble coupling (29), then tighten O-ring (29-1), holder (30), and mounting bolt (31). Lip of oil seal: Grease (G2-LI) Mounting bolt: 270 ± 31.9 Nm (28.25 ± 3.25 kgm) Ъ Push O-ring (29-1) into the shaft groove, and be careful not to get it caught. Ъ Remove lock set bolt (49), and check that it has been interchanged with the plug. 30-58 WA250-3L