Komatsu — ASSEMBLY

DISASSEMBLY AND ASSEMBLY TRANSMISSION 5. Rear oil seal, dust seal 1) Turn over front housing (44), and press fit oil seal (27) and dust seal (28). Ъ Press-fitting dimension a 36 ± 1 mm Ъ Press-fitting dimension b 28 ± 1 mm Lip of oil seal: Grease (G2-LI) 6. Idler gear 1) Press fit bearing (26) to gear (24), and install snap ring. 2) Press fit idler gear (24-1) to shaft (50). Ъ If the shaft has been removed, cool the shaft to -70 E C, then press fit it to dimension g. Ъ Shaft dimension g : 46.5 ± 0.5 mm 7. FORWARD and REVERSE clutch 1) Using tool A3, insert FORWARD and REVERSE clutch (25) in housing, then mesh REVERSE gear and idler gear (24-1) and assemble. WARNING!

Be careful not to get your fingers caught in the gears. 30-59 WA250-3L