DISASSEMBLY AND ASSEMBLY TRANSMISSION 4) Insert 1st and 3rd clutch (22) into bearing assembly portion. Ъ Check that each gear is correctly meshed when inserting into the bearing. Ъ Be careful about the meshing of 2nd and 4th clutch gear (21) and the emergency drive gear when assembling. Ъ If the gears are not properly meshed, rotate slightly to assemble. Do not use force. 9. Seal ring Install seal rings (20) to each shaft. Ъ Coat the seal rings well with oil, then assemble and check that the shaft rotates smoothly by hand. Seal ring Transmission oil 10. Pump (torque converter, loader) 1) Press fit bearing (19) to shaft (18).
Ъ Press fit so that there is no clearance at the stepped portion of the shaft. 2) Assemble gear (14) and snap ring (15) inside rear housing (11), then insert shaft (18) from pump mount end. 30-61 WA250-3L